Extraction of trimyristin from nutmeg lab

The purpose of this lab is to extract trimyristin from nutmeg with the organic substance, diethyl ether, to evidently produce trimyristin with a small portion of myristicin solid-liquid extraction.

It was also proven that trimyristin is soluble in acetone, the substance we used for recrystallization. Clamp the flask, not the condenser!

Thus using a relatively nonpolar solvent, trimyristin can be easily extracted by the concept of "like dissolves like". I secured the flask to the three-pronged clamp on the stand over the sand bath to heat for 45 minutes.

Trimyristin does not dissolve in water, a characteristics it shares with various other fatty acids and oily compounds However, it dissolves quite easily in chloroform, ethanol, benzene, ether and dicloromethane.

I got almost no crystals in the second recrystallization; they were visible, but not plenty enough to be put into the mel-temp device.

Following are the details of how to go about it: Clamp the Buchner flask to a retort stand! After you have isolated trimyristin from nutmeg as per the above instructions, weigh the resultant extract, calculate the ratio to total nutmeg volume and jot down the percent extracted of trimyristin from 5 grams of nutmeg.

T-1 and place the filter paper in the funnel - flute the filter paper with diethyl ether - pour the contents of the RB flask in Part A into the new RB flask Part C: This Extraction of trimyristin from nutmeg lab a result of a loss of the samples during the partition process, reflux, as well as recrystallization.

I added 3mL of tert-butyl methyl ether and 3 boiling chips, connected the black distiller connector to the flask, and the distillation column.

Now, as far as extraction of trimyristin from nutmeg is concerned, it is done using ground or powdered nutmeg and ether. Ether The purpose of this experiment was to illustrate the extraction of a solid natural product from its natural source by partition with the aid of an organic solvent.

The remains were the yellow solid of crude trymyristin mentioned in the lab description. I put 2 mL of tert-butyl methyl ether into the round bottom flask, heated it again for about five minutes, and repeated the same procedure.

Then extraction is used to partition the desired product into a solvent with a better solubility to the desired product than the previous solvent OR it is used to partition the undesired products out of the solvent. The crystals were then air dried and placed on a piece of filter paper. In this lab, the organic solvent of acetone is used to partition the trimyristin out of its original organic solvent, diethyl ether, in order to obtain a more purified crude product using temperature.

Extraction of Trimyristin from Nutmeg

Extraction of Trimyristin from Nutmeg Weighed down by the sudden spurt in practical sessions at college? By allowing the water in the condenser tubes to run in a counter-current flow, this allows the condenser column to be very cold such that any vapours given off are cooled back to liquid, and fall back into the reaction vessel.

It is a chemical derivative of myristic acid, a triglyceride to be specific. The relative abundance of trimyristin in nutmeg makes it a potentially necessary substance to partition. To purify the product, separation by simple distillation is used in order to distill most of the diethyl ether off from the filtrate.

In this lab, a water bath is used heated by a heating mantel since the experiment calls for low temperatures of degrees celsius. Now, allow the filtrate to stand uncovered so that the ether evaporates, removing all traces of impurity from the isolated filtrate.

Extraction, distillation, recrystallization, and chromatography are used the techniques that are used to isolate and purify chemical compounds from natural sources. Coming back to trimyristin before this chemistry tutorial gets any more diverted and turns into a full-fledged botany lecture!

Fix the condenser to this nutmeg-diethyl ethanol mixture containing flask and secure it properly in the metal block. Extraction is the process by which a compound or mixtures of, is transferred by separation from one phase into another. It settled again and I pipetted it into a 25mL Erlenmeyer flask, through a pressure filtration device plastic pipette with a small hole in the bulbin order to leave behind as much solid as possible.

Now, place this entire assembly of apparatuses upon a hot plate and heat for about minutes. The extraction of nutmeg seed to isolate trimyristin was performed in this lab.

Extraction from nutmeg

Since volatile inflammable substances ether, ethanol and heat are used in this procedure, be very careful while conducting this experiment.Trimyristin from Nutmeg.

This experiment illustrates the process of obtaining a pure organic compound from a natural source. Normally, because extracts from natural sources contain complex mixtures of compounds, isolation of a single pure compound requires long.

ISOLATION OF TRIMYRISTIN FROM NUTMEG ABSTRACT The purpose if the experiment was to extract the Trimyristan from ground nutmeg using extraction, distillation and recrystallization procedures.

This experiment involves extraction and separation techniques that yield a purified product. Isolation of Trimyristin from Nutmeg by Extraction Introduction: Extraction is the physical process by which a compound or mixture of compounds is transferred from one phase into another.

We will be looking specifically at an organic solvent extraction which is a type of solid-liquid extraction. The purpose of this lab is to extract trimyristin from nutmeg with the organic substance, diethyl ether, to evidently produce trimyristin with a small portion of myristicin (solid-liquid extraction).

The Isolation of Trimyristin From Nutmeg

Also, it is good to know that due to impurity the best way purify the product of trimyristin. Extraction, distillation, recrystallization, and chromatography are used the techniques that are used to isolate and purify chemical compounds from natural sources.

The extraction of nutmeg seed to isolate trimyristin was performed in this lab. Trimyristin does not dissolve in water, a characteristics it shares with various other fatty acids and oily compounds However, it dissolves quite easily in chloroform, ethanol, benzene, ether and dicloromethane.

Now, as far as extraction of trimyristin from nutmeg is concerned, it is done using ground or powdered nutmeg and ether. Heat is applied to isolate the trimyristin from the nutmeg solids and it gets .

Download
Extraction of trimyristin from nutmeg lab
Rated 4/5 based on 75 review
(c)2018